Bonjour,
Pouvez-vous me dire s'il y a un moins pour lors de la FAO l'ordre de découpe du DXF soit respecter.
Exemple : je crée une barrière. Lorsque mon dessin est fini, je fais OC, puis MO pour voir l'ordre et si c'est ok, après je fais KP.
Mais quand je découpe mon fichier, il ne respecte pas l'ordre du DXF.
Y a-t-il une solution ?
MacOS Big Sur, QCAD-CAM 3.25.2.12, Post processeur LaserGRBL (offset) mm
Merci
ORDRE découpe
Forum rules
Indiquez toujours votre système d'exploitation et votre version de QCAD.
Indiquez le post processeur utilisé.
Joignez les fichiers de dessin et les captures d'écran.
Postez une question par sujet.
Indiquez toujours votre système d'exploitation et votre version de QCAD.
Indiquez le post processeur utilisé.
Joignez les fichiers de dessin et les captures d'écran.
Postez une question par sujet.
Re: ORDRE découpe
Traduction de Google
Bonjour,
QCAD optimisera mathématiquement le chemin d'outils - il ne suivra pas cet ordre. Si vous devez contrôler l'ordre exact, vous devez créer un chemin d'outils individuel pour chaque contour.
Serait-ce l'ordre que vous recherchez? Cela se fait en deux étapes ...
Bonjour,
QCAD will optimize mathematically the tool path - it will not follow that order. If you need to be in control of the exact order, you need to create an individual tool path for each contour.
Would this be the order you are looking for? It is done in two steps ...
Bonjour,
QCAD optimisera mathématiquement le chemin d'outils - il ne suivra pas cet ordre. Si vous devez contrôler l'ordre exact, vous devez créer un chemin d'outils individuel pour chaque contour.
Serait-ce l'ordre que vous recherchez? Cela se fait en deux étapes ...
Bonjour,
QCAD will optimize mathematically the tool path - it will not follow that order. If you need to be in control of the exact order, you need to create an individual tool path for each contour.
Would this be the order you are looking for? It is done in two steps ...
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: ORDRE découpe
Oui, je voudrais découper en évitant que le laser aille de droite à gauche pour éviter des décalages.
Re: ORDRE découpe
Quand vous dites chemin d'outils individuel pour chaque contour, c'est des profils de parcours d'outil FAO?
Re: ORDRE découpe
Oui, 1. KP pour les parties intérieures ...
... 2. KP pour la couture.
Yes, 1. KP for inner parts ...
pic
... 2. KP for couture.
pic
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."