Cutting off lines after radiusing

Drop in here to discuss whatever you want.

Moderator: andrew

Forum rules

Always indicate your operating system and QCAD version.

Attach drawing files and screenshots.

Post one question per topic.

Post Reply
n_spect_r
Active Member
Posts: 44
Joined: Tue Jun 18, 2019 12:09 pm

Cutting off lines after radiusing

Post by n_spect_r » Wed Oct 05, 2022 11:20 am

This may have been covered, and I may not have a good description but could not find an answer. In older versions, If I drew a square, then radiused the corners, the straight lines went away, in the current version the straight lines remain, and I break out the segments. Curious if there is a setting to change this. Thanks.

User avatar
andrew
Site Admin
Posts: 9019
Joined: Fri Mar 30, 2007 6:07 am

Re: Cutting off lines after radiusing

Post by andrew » Wed Oct 05, 2022 11:25 am

Please refer to the user manual at:
https://qcad.org/doc/qcad/latest/refere ... c/RoundPro

Check "Trim" if you want to trim the entities automatically. If the option is disabled, the two corner entities will remain untouched.

Post Reply

Return to “Chat”