QCAD.org Forum

Hi All
Can anybody please tell me, after drawing a lot of lines etc, what is the quickest way of getting back to the command line. I currently do it by by pressing escape or enter multiple times.
Many thanks
Graham

Have you tried the "Space key" on your keyboard ...?

Hi Husky
The space key does what it says, moves the cursor to the left/right, does not go back to command,
Graham

My mouse cursor is not moved by pressing the SPACE key.
The cursor inside the Command Line is obviously moved to the right by pressing SPACE key.

Like Husky said:
> Draw / Line from 2 points.
> Drew a bunch of lines.
> Hitted the space key and I am in the Command Line.

Do you have another approach?

Regards,
CVH

Hi All
Drew a bunch of lines.
Hit the SPACE KEY and the cursor goes to the right.
Hit the ESCAPE KEY several times and eventually got back to command line.
Still no further on.
Graham

IF there is a flashing "|" and it moves to the right when you press space bar then you are already in the command line. I remember when I first started with CP/M... I did not immediately comprehend whether I was at command prompt or in the application... was confusing where the application focus was. Then, in a blink it was obvious. But that was then.

Thanks Panchdara
Got it.
Graham

Glad to help Graham. Hopefully you'll have fun in QCAD. This forum seems to be the best place to pose your questions and, if history repeats itself, you'll always get the best constructive help/answers. Happy QCAD'n (it's Friday - "NO G")