Ha...
andrew wrote: ↑Mon Jan 06, 2020 6:22 pm
A "solid" is filled, a "face" isn't filled and the vertex order is different.
Good thing you mentioned this, saw a remark deeper in the code about that.
Cheked mine decoction:
CVH wrote: ↑Mon Jan 06, 2020 2:22 pm
A: The face section was an excact copy of the solid section.
No in Explode.js it isn't, my bad
must have paste twice without a new 'copy this'....
Corrected, Now I only have to create some faces
andrew wrote: ↑Mon Jan 06, 2020 6:22 pm
There's also something called a "trace" which as far as QCAD is concerned is the same as a "solid" but always with four vertices.
As Explode doesn't handle this, interpolation is left out too.
Or I might just put a dummy entry there...we will see.
Apart from the fact that it is not much of 'interpolation' in se...
Again some steps further,
Thanks,
CVH