Page 1 of 1
[SOLVED] Help testing Trial QcadCam Version: 3.23.0.0 (3.23.0)
Posted: Wed Nov 20, 2019 6:23 am
by John Hyslop
Hi All
I'm having trouble nesting these parts, could anyone help out here..
Best Regards
John
Re: Help testing Trial QcadCam Version: 3.23.0.0 (3.23.0)
Posted: Wed Nov 20, 2019 7:27 am
by Husky
Hi,
QCAD/CAM can't identify the proper shape of the largest part. The 20 mm Circle on the very left side needs a bit of trim work ...
- Husky-2019.11.19-02.png (17.16 KiB) Viewed 3832 times
After that is fixed a result could look like this one:
- Husky-2019.11.19-01.png (24.36 KiB) Viewed 3832 times
Re: Help testing Trial QcadCam Version: 3.23.0.0 (3.23.0)
Posted: Wed Nov 20, 2019 10:26 am
by John Hyslop
Hi Husky
Oops... Thanks for that...I did these parts when I 1st started using qcad I think I must of trimmed to vertical construction line through centre of arc...
Good pickup..I should of looked at that seeing as it seperated it when nested
Cheers
John
Re: [SOLVED] Help testing Trial QcadCam Version: 3.23.0.0 (3.23.0)
Posted: Wed Nov 20, 2019 12:11 pm
by John Hyslop
When my year is up I'm definitely going to upgrade to qcadcam just for the nesting feature.. it's brilliant...