Page 1 of 1
Snapping on center of a rectangular shape (4 lines)
Posted: Sun Jul 07, 2019 11:29 am
by Krischu
- Bildschirmfoto 2019-07-07 um 12.25.11.png (14.35 KiB) Viewed 5370 times
I want to put a drill hole (small circle) in the midpoint of a rectangle (formed of 4 separate surrounding lines). How can I adjust the snap mode such that the cursor snaps to the midpoint of the (green marked) area?
Re: Snapping on center of a rectangular shape (4 lines)
Posted: Sun Jul 07, 2019 5:19 pm
by Husky
In this particular situation you can use the "Center of Selection" snap. In other situation the "Middle Manual" snap will provide the solution.
Re: Snapping on center of a rectangular shape (4 lines)
Posted: Mon Jul 08, 2019 7:13 am
by Krischu
Husky wrote: ↑Sun Jul 07, 2019 5:19 pm
In this particular situation you can use the "Center of Selection" snap. In other situation the "Middle Manual" snap will provide the solution.
Thanks. Found it in the drop down menu (SK). Does not appear in the left icon bar.