Post Processors - Centroid
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Post Processors - Centroid
is there a specific post processor for Centroid Acorn ... would like to know pre purchase
Re: Post Processors - Centroid
Hi,
I don't think you need a special postprocessor.
All depends on the G-code dialect that is supported by the Centroid Acorn.
Of course one can create a custom postprocessor if that would be required.
Regards,
CVH
I don't think you need a special postprocessor.
All depends on the G-code dialect that is supported by the Centroid Acorn.
Of course one can create a custom postprocessor if that would be required.
Regards,
CVH
Last edited by CVH on Tue Nov 22, 2022 4:45 am, edited 1 time in total.
Re: Post Processors - Centroid
@CVH
Hi,
Thanks for response. Any info on post processor creation would be more than welcome
Thanks
Hi,
Thanks for response. Any info on post processor creation would be more than welcome
Thanks
Re: Post Processors - Centroid
There is not much to go on ...
https://qcad.org/en/qcad-cam-postprocessor
But you can get help with very specific questions in this forum.
Regards,
CVH
https://qcad.org/en/qcad-cam-postprocessor
But you can get help with very specific questions in this forum.
Regards,
CVH