Milling out the entire area of a polyline
Posted: Sat May 15, 2021 5:14 pm
As the subject implies I'd like to mill out the area described by a polyline but I've not seen any (easy) way to do it.
I've tried to create a series of concentric polylines, each one smaller by the diameter of the tool but selecting them an adding them to the tool path seems to confuse QCad. My guess is that it's not sure what the "inside" is and every other path goes on the wrong side of the line. I haven't tried creating a separate tool path for each one but my guess is that it would work.
I've tried to create a series of concentric polylines, each one smaller by the diameter of the tool but selecting them an adding them to the tool path seems to confuse QCad. My guess is that it's not sure what the "inside" is and every other path goes on the wrong side of the line. I haven't tried creating a separate tool path for each one but my guess is that it would work.