Default save as
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Default save as
I use some older software that will not import a DXF in any format newer than R12. Is there a way to set Qcadcam to save in this by default? When I try to set it in preferences, the lowest format is R18. Thaks.
Re: Default save as
DXF/DWG Format versions < R18 should not be used as default since they cannot hold all information and entity types supported by QCAD. Saving in an older format version might result in entity conversions or entity loss, so this should always be seen as an export.
You can override this behaviour by manually editing the QCAD3.ini / QCAD3.conf file:
Note that this is not recommended for the above mentioned reasons.
You can override this behaviour by manually editing the QCAD3.ini / QCAD3.conf file:
Code: Select all
[SaveAs]
Filter=R12 [LT2] DXF Drawing [OpenDesign] (*.dxf)