Postprocesor line numbers
Posted: Fri Mar 13, 2020 3:43 am
Hi,
I've recently found QCAD/CAM. I am in the middle of testing it out to see if it will fit my workflow, and really like it thus far. Prior to this I used SVG's with JSCUT on my MPCNC running a Marlin 2.0 firmware with good success, but with a very inefficient workflow.
In JSCut I have been used to getting g-code similar to:
When I generate g-code from QCAM I get something like the following:
Which seems fine in it's own, but the line numbers are causing issues with the machine.
I have tried altering the GCodeBase.js file by removing the where I have found them, but it continues to write the line numbers. I confirmed that the file 'is' updating by altering the in the file and see those changes reflected.
Can anyone point me in the right direction on how to remove the line numbers so I can get it working with my MPCNC?
Thanks,
Dan
I've recently found QCAD/CAM. I am in the middle of testing it out to see if it will fit my workflow, and really like it thus far. Prior to this I used SVG's with JSCUT on my MPCNC running a Marlin 2.0 firmware with good success, but with a very inefficient workflow.
In JSCut I have been used to getting g-code similar to:
Code: Select all
G1 X803.1734 Y79.0651 F480
G1 X803.3870 Y79.0697
G1 X803.3870 Y79.0699
Code: Select all
N10 G0 Z4
N20 G0 X33.3 Y30
N30 T1 M6
N40 S30000 M03
N50 G0 Z2
I have tried altering the GCodeBase.js file by removing the
Code: Select all
[N]
Code: Select all
this.fileExtensions
Can anyone point me in the right direction on how to remove the line numbers so I can get it working with my MPCNC?
Thanks,
Dan