Page 1 of 1
Is this where I report problems?
Posted: Fri Sep 06, 2019 12:32 am
by chuckt
In the profile dialog, if I set the start depth and the cut depth to the same value, the system goes into an endless loop. To stop it, you have to quit QCAD.
I am running on Ubuntu 18.04LTS and I have QCAD/CAM V3.23
I know this is a stupid thing, but it I wish it would just bail, rather than endlessly loop.
Re: Is this where I report problems?
Posted: Fri Sep 06, 2019 6:30 am
by Husky
For a bug report or a feature request please use
https://www.qcad.org/bugtracker
A bug report posted in this forum could be "forgotten" what never happens in that mentioned dedicated forum.
Unfortunately that forum needs a separate registration, your login from this forum will not work.
Re: Is this where I report problems?
Posted: Fri Sep 06, 2019 6:46 pm
by chuckt
I looked at the bug tracker, but I did not see a way to register or login. Do I need to apply or something?
Re: Is this where I report problems?
Posted: Fri Sep 06, 2019 7:32 pm
by Husky
chuckt wrote: ↑Fri Sep 06, 2019 6:46 pm
Do I need to apply or something?
Yes.There should be a link (Login) at the upper right corner or just use this ling for the first registration:
https://www.qcad.org/bugtracker/index.php?do=register