In the profile dialog, if I set the start depth and the cut depth to the same value, the system goes into an endless loop. To stop it, you have to quit QCAD.
I am running on Ubuntu 18.04LTS and I have QCAD/CAM V3.23
I know this is a stupid thing, but it I wish it would just bail, rather than endlessly loop.
Is this where I report problems?
Moderator: andrew
Re: Is this where I report problems?
For a bug report or a feature request please use https://www.qcad.org/bugtracker
A bug report posted in this forum could be "forgotten" what never happens in that mentioned dedicated forum.
Unfortunately that forum needs a separate registration, your login from this forum will not work.
A bug report posted in this forum could be "forgotten" what never happens in that mentioned dedicated forum.

Unfortunately that forum needs a separate registration, your login from this forum will not work.
Work smart, not hard: QCad Pro
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
Re: Is this where I report problems?
I looked at the bug tracker, but I did not see a way to register or login. Do I need to apply or something?
All the best!
Chuck Tilbury
http:/whistlemaker.com
Chuck Tilbury
http:/whistlemaker.com
Re: Is this where I report problems?
Yes.There should be a link (Login) at the upper right corner or just use this ling for the first registration:
https://www.qcad.org/bugtracker/index.php?do=register
Work smart, not hard: QCad Pro
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!