Toolpaths dissapear in SnapShot 3.22.1.2
Posted: Sat Jun 22, 2019 8:11 pm
Using SnapShot 3.22.1.2, Windows 10.
I got very excited about the automatic nesting mentioned in the Changelog and downloaded the SnapShot 3.22.1.2 right away to check it out. I could not find the new nesting feature in the CAM menu, i guess it not ready yet. I will "patiently" wait until the next SnapShot release.
But I found that if i have Toolpaths showing on screen, when i zoom or pan, when the starting point of the toolpath (usually 0,0) goes out of the screen, all of the toolpaths dissapear. They will re-appear if i zoom or pan again, when the starting point is back on screen.
I got very excited about the automatic nesting mentioned in the Changelog and downloaded the SnapShot 3.22.1.2 right away to check it out. I could not find the new nesting feature in the CAM menu, i guess it not ready yet. I will "patiently" wait until the next SnapShot release.
But I found that if i have Toolpaths showing on screen, when i zoom or pan, when the starting point of the toolpath (usually 0,0) goes out of the screen, all of the toolpaths dissapear. They will re-appear if i zoom or pan again, when the starting point is back on screen.