crash QCAD/CAM v3.20
Posted: Mon Apr 30, 2018 4:26 pm
Hi Andrew,
thank you very much for the new version. The option to set taps is very helpfull. Great work!
I think you are intrested in a bug since that version (I'm not shure, maybe the version before).
1. load a file
2. close the file
3. load the same file again
4. click CAM Configuration -> 100% CPU -> kill -9
A click on CAM Configuration when opened first time works.
I use the Linux Version with leap 42.3 all updates.
The file used is attached.
If you nee more information, no problem.
Best Regards,
Christof
thank you very much for the new version. The option to set taps is very helpfull. Great work!
I think you are intrested in a bug since that version (I'm not shure, maybe the version before).
1. load a file
2. close the file
3. load the same file again
4. click CAM Configuration -> 100% CPU -> kill -9
A click on CAM Configuration when opened first time works.
I use the Linux Version with leap 42.3 all updates.
The file used is attached.
If you nee more information, no problem.
Best Regards,
Christof