Offset

Use this forum to ask questions about how to do things in QCAD 2.1/2.2.

Moderator: andrew

Locked
roguepoint
Registered Member
Posts: 2
Joined: Wed Jun 25, 2008 12:38 am
Location: Nashville,TN

Offset

Post by roguepoint » Wed Jun 25, 2008 12:51 am

I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command, and is there a print friendly manual?

User avatar
andrew
Site Admin
Posts: 9037
Joined: Fri Mar 30, 2007 6:07 am

Re: Offset

Post by andrew » Wed Jun 25, 2008 10:16 am

roguepoint wrote:I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command,
Try the command 'offset' or Draw - Line - Parallel
roguepoint wrote: and is there a print friendly manual?
http://www.ribbonsoft.com/qcad_doc.html

Locked

Return to “QCAD 2.1/2.2 'How Do I' Questions”