Page 1 of 1
Installing on Linux
Posted: Wed May 09, 2018 3:48 pm
by omng945
I currently have the trial version installed, came that way. I upgraded to Pro, downloaded on a flash drive but cannot get this thing to install. I’m using Linux 32 bit, i686. I click on properties and it will not let me change the permissions. Says cannot set permissions on symlinks. I need help!
Re: Installing on Linux
Posted: Wed May 09, 2018 3:53 pm
by andrew
Please follow our very detailed step by step instructions at:
http://www.qcad.org/en/component/conten ... tion-linux
If the problem persists, please indicate in which step and post screenshots, exact error messages, etc.
Re: Installing on Linux
Posted: Wed May 09, 2018 6:45 pm
by omng945
I figured it out, I had to put the files in a specific folder (Downloads) on the computer.