QCAD hung up while scaling
Posted: Sun Dec 24, 2017 9:13 am
I haven't tried to reproduce this, but I sure short-circuited QCAD.
I was scaling down a block and accidentally entered two decimal points: .o.o5
The result was QCAD hanging up. I've tried clicking left and right, simultaneously clicking left and right, hitting ESC, DELETE, ESC & DELETE combo, but all I get is that crosshair that says "Grid" at it's center...the same one it shows when QCAD wants you to find a point on an entity before moving it. When I tried to scale it again, that's when I saw my last entry, having two decimal points in it. I was surprised that passed as a valid field entry.
Here's a screenshot and the file. Not sure if the file will show you anything, but it did allow me to save it. I just can't do any work to it until I restart QCAD.
Slyde
I was scaling down a block and accidentally entered two decimal points: .o.o5
The result was QCAD hanging up. I've tried clicking left and right, simultaneously clicking left and right, hitting ESC, DELETE, ESC & DELETE combo, but all I get is that crosshair that says "Grid" at it's center...the same one it shows when QCAD wants you to find a point on an entity before moving it. When I tried to scale it again, that's when I saw my last entry, having two decimal points in it. I was surprised that passed as a valid field entry.
Here's a screenshot and the file. Not sure if the file will show you anything, but it did allow me to save it. I just can't do any work to it until I restart QCAD.
Slyde