Setting up cam expert for my machine
Posted: Thu Dec 03, 2009 10:44 pm
Hi all , I have an Amada laser 667mkII with OM Fanuc controller .
I have attached a small snippet a typical g code , it is a very different animal to the code that I am getting out of cam expert .
Q . is there a way to configure the code that will be generated with cam expert ?
I am keen to start using my mac for the task rather than my Windows PC.
G00 X546.535 Y620.459
M98 P100
F3500.
G03 X544.535 Y618.459 I0 J-2.
G01 X544.535 Y617.459
X544.535 Y581.79
G03 X545.857 Y580.468 I1.322 J0
G01 X617.195 Y580.468
G03 X618.517 Y581.79 I0 J1.322
G01 X618.517 Y653.128
G03 X617.195 Y654.45 I-1.322 J0
G01 X545.857 Y654.45
G03 X544.535 Y653.128 I0 J-1.322
G01 X544.535 Y617.459
M61
Thanks Rick
I have attached a small snippet a typical g code , it is a very different animal to the code that I am getting out of cam expert .
Q . is there a way to configure the code that will be generated with cam expert ?
I am keen to start using my mac for the task rather than my Windows PC.
G00 X546.535 Y620.459
M98 P100
F3500.
G03 X544.535 Y618.459 I0 J-2.
G01 X544.535 Y617.459
X544.535 Y581.79
G03 X545.857 Y580.468 I1.322 J0
G01 X617.195 Y580.468
G03 X618.517 Y581.79 I0 J1.322
G01 X618.517 Y653.128
G03 X617.195 Y654.45 I-1.322 J0
G01 X545.857 Y654.45
G03 X544.535 Y653.128 I0 J-1.322
G01 X544.535 Y617.459
M61
Thanks Rick