Search found 4 matches

by DanShrader
Sat Mar 14, 2020 3:54 am
Forum: QCAD/CAM
Topic: Postprocesor line numbers
Replies: 5
Views: 7625

Re: Postprocesor line numbers

Hi Andrew, I tested out the code and added the following: this.outputOffsetPath = true; above the: this.empty = ""; It's working awesome now with the MPCNC! Thanks for your help. For those looking for the additional settings from the CAM Config menu I simply have the following: Spline interpolation ...
by DanShrader
Fri Mar 13, 2020 12:20 pm
Forum: QCAD/CAM
Topic: Postprocesor line numbers
Replies: 5
Views: 7625

Re: Postprocesor line numbers

Awesome, thanks Andrew.

I was going a different approach in my editing.

I’ll test it out tonight.
by DanShrader
Fri Mar 13, 2020 11:21 am
Forum: QCAD/CAM
Topic: Postprocesor line numbers
Replies: 5
Views: 7625

Re: Postprocesor line numbers

Hi Andrew, In QCAM I am currently using the 'G-Code (G41/G42) [mm]' in QCAM, but I had tried a few other ones in there before going the route of 'attempting' to modify the post processor. As far as JSCut I am not sure the name of the post processor there. I dug into the source code a little there an...
by DanShrader
Fri Mar 13, 2020 3:43 am
Forum: QCAD/CAM
Topic: Postprocesor line numbers
Replies: 5
Views: 7625

Postprocesor line numbers

Hi, I've recently found QCAD/CAM. I am in the middle of testing it out to see if it will fit my workflow, and really like it thus far. Prior to this I used SVG's with JSCUT on my MPCNC running a Marlin 2.0 firmware with good success, but with a very inefficient workflow. In JSCut I have been used to...

Go to advanced search