Search found 4 matches
- Sat Mar 14, 2020 3:54 am
- Forum: QCAD/CAM
- Topic: Postprocesor line numbers
- Replies: 5
- Views: 7670
Re: Postprocesor line numbers
Hi Andrew, I tested out the code and added the following: this.outputOffsetPath = true; above the: this.empty = ""; It's working awesome now with the MPCNC! Thanks for your help. For those looking for the additional settings from the CAM Config menu I simply have the following: Spline interpolation ...
- Fri Mar 13, 2020 12:20 pm
- Forum: QCAD/CAM
- Topic: Postprocesor line numbers
- Replies: 5
- Views: 7670
Re: Postprocesor line numbers
Awesome, thanks Andrew.
I was going a different approach in my editing.
I’ll test it out tonight.
I was going a different approach in my editing.
I’ll test it out tonight.
- Fri Mar 13, 2020 11:21 am
- Forum: QCAD/CAM
- Topic: Postprocesor line numbers
- Replies: 5
- Views: 7670
Re: Postprocesor line numbers
Hi Andrew, In QCAM I am currently using the 'G-Code (G41/G42) [mm]' in QCAM, but I had tried a few other ones in there before going the route of 'attempting' to modify the post processor. As far as JSCut I am not sure the name of the post processor there. I dug into the source code a little there an...
- Fri Mar 13, 2020 3:43 am
- Forum: QCAD/CAM
- Topic: Postprocesor line numbers
- Replies: 5
- Views: 7670
Postprocesor line numbers
Hi, I've recently found QCAD/CAM. I am in the middle of testing it out to see if it will fit my workflow, and really like it thus far. Prior to this I used SVG's with JSCUT on my MPCNC running a Marlin 2.0 firmware with good success, but with a very inefficient workflow. In JSCut I have been used to...