QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Performance Issue
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System Ubuntu Linux
  • Severity Low
  • Priority Very Low
  • Reported Version 3.24.3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 2
  • Private
Attached to Project: QCAD Bugtracker
Opened by reint kamp - 14.04.2020
Last edited by reint kamp - 14.04.2020

FS#2063 - Bad performance while zooming inside layout block with hatches

Zooming in and out is lagging to the point of unusable. This is happening in a layout block with the cursor pointing inside geometry with hatches. When the cursor is pointing outside the geometry zooming works as expected.
The attached file has a very simplified testcase that shows this problem almost in the same way as a more complex drawing with multiple layers and hatches.

edit: I also attached the more complex drawing because it is a bit unclear to me where the lagging stops. Outside the viewport or outside the paper.

I just noticed the selection box has the same problem!

reint kamp commented on 29.04.2020 07:49

I found out that locking the layer where the viewport is in will make it perform much better.

CVH commented on 24.11.2020 10:39

Also related to cloning load of hatches.
Gravel, Gravel1 is the culprit here
See: https://qcad.org/rsforum/viewtopic.php?f=33&t=7340&p=28515&hilit=lag#p28515

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing