- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by H. Stiekema - 09.10.2019
Last edited by Andrew - 09.10.2019
Opened by H. Stiekema - 09.10.2019
Last edited by Andrew - 09.10.2019
FS#1963 - Bug Font Standard OR Cam Config
Hallo Andrew
Confronted with a bug in font Standard glyph āsā (small S),
and a solution.
Any reason for offsetting the letters? These entities are very small and I can see how offsetting them might increase a small error and cause problems. Perhaps, text can be processed “on” the contour instead?
Yes, a very good reason when using a lasercutter for cutting PCB's.