QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Windows 7
  • Severity Low
  • Priority Very Low
  • Reported Version 3.22.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by CVH - 06.07.2019
Last edited by Andrew - 06.07.2019

FS#1918 - Splines whit control points of order 1 and 4 not selected with partially selecting cursor R>L draw

Set up a spline with control points let’s say of the order 3.
Clone it 3 times with some offset in x&y.
Edit the degree property and set 1ste to 1, 2nd to 2, aso
Draw select partially from right to left.
Those of the order 1 and 4 aren’t selected.


Closed by  Andrew
06.07.2019 19:41
Reason for closing:  Fixed
Additional comments about closing:  

Fixed for degree 1, out of scope for degree 4 and higher (won't fix / implement)

Andrew commented on 06.07.2019 19:40

Thanks. Degree 1 splines (polylines) will be implemented / fixed for the next release.

For degree 4 and higher, unfortunately, I'm going to have to close this as "out of scope". I'm unaware of any algorithms to deal with intersections of splines of degree 4 and higher. Splines of degree 4 and higher are mostly of academic interest and mainly supported in QCAD for compatibility reasons.


Available keyboard shortcuts


Task Details

Task Editing